top of page

How to Mount a Fish Finder on a Kayak

4 days ago
3 min read

A fish finder only helps if you can read it. A screen buried at your feet, flopping on a loose arm, or washed out by sun is dead weight. Getting the mount right is a one-time job that pays off every trip after. Here is how to think about it.

Where the screen should sit

Before you buy anything, sit in your kayak and reach forward. The screen belongs up front, within arm's reach from the seat, low enough to read sitting down and high enough that the deck does not block it. You will adjust range, sensitivity, and waypoints all day, so if you have to stand up or twist around to touch it, it is in the wrong place. It also needs to stay clear of your paddle stroke and your rod tips — a screen that eats a rod tip on the backcast is a screen you will regret.

What to mount it on

There are two routes, and the right one depends on your kayak.

If you run an Old Town AutoPilot, the DeckClear Command Platform for AutoPilot ($97.95) is built for that kayak. It gives your fish finder and controls a home right up front, where you can see them and reach them, without drilling into the hull.

For any other kayak with standard gear tracks, the Universal DeckClear T-Track Command Platform ($107.95) does the same job. It mounts to a T-track, so it works across kayaks with standard accessory rails, and you can move it or remove it without leaving holes behind.

Both are 3D-printed, made in the USA, and built to take abuse. Pick the one that matches your kayak — that is the whole decision.

One screen or two

If you run two displays — say a mapping unit and a LiveScope screen — the DeckClear Universal Dual Display Stand ($75.95) holds two Garmin displays on the platform, staggered or stacked so you can read both from the seat. If you run one screen, the platform alone is enough, and you can add the stand later if a second display joins the setup.

Don't forget the glare

A mount solves position. It does not solve sun. On bright mornings a bare screen washes out, and no amount of brightness setting fixes a direct reflection.

The FoldFlat SunVisor ($81.95–$109.95) is a sunshade and screen cover for Garmin displays. It cuts the glare, covers the screen when you are not using it, folds flat, and can just be left on. It fits Garmin ECHOMAP UHD2 7x and 9x and Ultra 1st and 2nd Gen units — the 73sv, 93sv, and 106sv sizes — and works on kayaks, bass boats, and pontoons. Twelve-inch and 16-inch versions are in the works.

Mounting checklist

  1. Sit in the kayak first. Decide the screen position by reaching for it before you mount anything.

  2. Pick the mount that matches your kayak: the AutoPilot platform or the universal T-track platform.

  3. Route cables so they cannot snag a hook, a net, or a paddle.

  4. Test it on the water before a tournament day. Adjust the angle for sun, and make sure the screen stays readable when you are sitting low.

What to get

All YakRigLabs gear is 3D-printed and made in the USA. Many parts are print-to-order and take 2–3 days to print, so order before you need it.

 
 
 

Recent Posts

See All

Comments


bottom of page